Posts: 2
Joined: Wed Jun 12, 2019 3:32 am

LCD changes

Wed Jun 12, 2019 3:35 am

I was tweaking my printer yesterday with one of the awesome prints from thingiverse. The way i was adjusting it was by using the LCD:

The question is:
Where I find the Flow rate which is dialed in at 200 on the LCD and my slicer extrusion multiplier is .94. How would i go about calculating the new extrusion multiplier.

Speed, on this setting I dialed the speed in at 80 rather than 100. How would i set this under the speed settings in the slicer.

Return to “Troubleshooting and Bug Reports”