Posts: 1
Joined: Sun Jun 30, 2019 12:27 pm

Da Vinci Jr 1.0

Sun Jun 30, 2019 1:41 pm

I bought the Simplify3D software in Dec and since then I can’t one successfull print to print. I have tried everything. G Code Z offset, Toolhead offsets, temp, speed etc. About every setting has been changed and I still can’t get n successful print. Has anyone managed to print successfully with simplify3d and a da Vinci jr printer. Can you please share your settings if you did? I feel that a cost tag of about $150 is a bit harsh if I can’t get anything to print properly

Return to “Troubleshooting and Bug Reports”