Hello.
Regarding PVA usage in Dense Support on a TPU part, i'm finding that the speed has to be quite slow for those interface layers.
The thing is that these are large models and printing every part of the support at that slowest speed would take days (on top of the regular pint time).
(The support has to be all PVA, so suggesting only the interface layers should be will be pointless.)
I have occasionally went through the G-code and replaced the speeds for Dense Support regions, but that takes hours, and if i change anything on S3D it will go downs the drain.
Would there any way to do this via scripts on S3D? (i Was reading about those but i'm not skillful enough to get to an hypothesis).
Tks o/