The latest version added an intelligent bridging function where it would bridge "perpendicular" across the gap instead of at the normal "infill angles"
for a lot of bridging this makes sense but for massive open area square bridging this does not work so well.
bridging at 45' starting in a corner and expanding (normal old style bridging) works better in this scenario as the corner is a very tiny bridge and it slowly gets longer and longer and the previous successful strands "assist" the follow on strands to help make them successful.
but the new bridging takes the 100mm gap straight on without starting in a corner so once it fails (usually the first strand) it never recovers.
so how do I tell it not to do that when it does not make sense too?