my first thought was dirty z screws, but it all happens around hole prints.
the printer in question is a cr10s with the bondtech direct drive system. material is PLA.
any help or pointers is greatly appreciated, thank you !
Z artifact after hole
I'm looking for an explanation for extrusion artifact i get on the z-axis
my first thought was dirty z screws, but it all happens around hole prints.
the printer in question is a cr10s with the bondtech direct drive system. material is PLA.
any help or pointers is greatly appreciated, thank you !
my first thought was dirty z screws, but it all happens around hole prints.
the printer in question is a cr10s with the bondtech direct drive system. material is PLA.
any help or pointers is greatly appreciated, thank you !
