Hi Everyone,
I am personally new to the 3D printing universe! I am having a couple issues actually, and I am sure they are related. I have a couple parts of my external support that will not render near parts of the actual model.
I downloaded a model I purchased from Heroforge I am currently trying to get printed. Its beak is not supported even though it actually passes the Max overhang limit, and where the part juts out for a pack on this chest, it just doesn't provide any support between those layers. That includes sections where there are shoulder pads and the arms are under them.
Please pardon the unprofessional images, I just needed something to illustrate the issue.
When I print this, it goes good up until the arm cuts off the support and when it reaches the continue point, it just creates "Silly string" in mid air and then "sticks" it to the outer layer of the model making it look... Hairy.
Any help would be greatly appreciated!! Thank you!