what is the reason for this gap ?
in my case, I print a cylinder and every layer gets this gap
Thank you
infill gap
- Attachments
-
Re: infill gap
Can you please post the factory file for the above cylinder. File Menu>>>>Save Factory File as
Without seeing exactly where your settings are, its almost impossible to give a sensible answer....
Without seeing exactly where your settings are, its almost impossible to give a sensible answer....
Doug Kightley
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
Re: infill gap
To fine tune the settings to get a good print for this particular shape file, all I needed to do was to change the infill type to "Grid" and the Outline overlap to "11%"
Doug Kightley
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
