single outline corkscrew printing mode does not work

[SPEED]

I'm trying to print a single perimeter square and the single outline corkscrew printing mode does not work
It still keeps printing one layer clockwise the other layer counterclockwise
I didn't try to print it but i can clearly see it on the preview mode

[dkightley]

Have a read of my post on this thread: viewtopic.php?f=9&t=13442&p=51350&hilit=vase#p51350

It will explain where you are going wrong.

[SPEED]

How do you assume my model is not printable ?
I'm not an idiot.

[Overheal]

Can you post the factory file so we can take a look please

[dkightley]

How do you assume my model is not printable ?
I'm not an idiot.

I don't.....and I'm glad you're not!

Nuf said from me....

[SPEED]

Can you post the factory file so we can take a look please

Like i said it's a square with 1 perimeter can't get any simpler than that but here it is.
Ended up adding 1 more perimeter because not even Cura could print it right...

That's the version with the 2 perimeters since i overwritten the 1 layer version still corkscrew dosn't work as it should tho (1 direction)

[horst.w]

I'm not an idiot.

You are sure?

How do you assume my model is not printable ?
It will be, but not as a hollow body with a definide wall width. Your model has 2 walls, an outer and an inner one. How you want to print it with onle one perimeter?

Sir, you havn't understood anything! Go back to Cura, they have more and good automatism than S3D. Here you must invest more than pressing a knob.

horst.w
GER

Corkscrew.png (33.8 KiB) Viewed 3943 times

[SPEED]

I'm not an idiot.

You are sure?

How do you assume my model is not printable ?
It will be, but not as a hollow body with a definide wall width. Your model has 2 walls, an outer and an inner one. How you want to print it with onle one perimeter?

Sir, you havn't understood anything! Go back to Cura, they have more and good automatism than S3D. Here you must invest more than pressing a knob.

horst.w
GER

Corkscrew.png

Like i said i am not an idiot.
You are the one who hasn't understand anything.
It doesn't matter how many perimeters your model has corkscrew will always print it with one perimeter. That's it's function.
It's just sad that people so ignorant on 3dprinting try to teach others.

[wirlybird]

I'm not an idiot.

You are sure?

How do you assume my model is not printable ?
It will be, but not as a hollow body with a definide wall width. Your model has 2 walls, an outer and an inner one. How you want to print it with onle one perimeter?

Sir, you havn't understood anything! Go back to Cura, they have more and good automatism than S3D. Here you must invest more than pressing a knob.

horst.w
GER

Corkscrew.png

Like i said i am not an idiot.
You are the one who hasn't understand anything.
It doesn't matter how many perimeters your model has corkscrew will always print it with one perimeter. That's it's function.
It's just sad that people so ignorant on 3dprinting try to teach others.

So insulting the people who are trying to help by explaining the issue to you is how you go about getting help?

Maybe try dropping the attitude and listen to what has been expalined. You have been given the solution.

Good luck with it.

[horst.w]

No comment