Modifier Mesh

[davoshaw]

I just purchased S3d and wow I’m disappointed it doesn’t have this feature. I came from ideamaker and it has this feature.

Is this going to release soon??

[S3D-Jake]

Davoshaw,

Thanks for your interest in this feature being added to the software. I've documented this feature previously. I will continue to monitor this thread for additional interest and input.

[JorgD]

I can assure you there is massive interest in this feature. Being able to change infill parameters for parts of a model saves a lot of time and material on huge models on a Creality S5. Why infill the whole model at the densest requirement when only a small part needs dense infil? And sadly this part can not be separated by layer height.

[1hander]

i vote for this on too

[dattrax]

I'd like to vote for this as well. Slic3r isn't very good in other regards, so S3D is still my slicer of choice. I can't really do threaded inserts with S3D, as I need to change the number of perimeters for the entire part rather than just the places the inserts go.

Hopefully it'll make it into v5

[waterbornewarrio]

Modifier mesh still needed!

[cmadson]

@Simplify3D 10 years later and we are still waiting....