"WARNING: CRC Mismatch detected"

[Zekeman]

I am pretty positive this really is not a software issue, but I have been getting all of the sudden a lot of these errors on a print, which is displayed in the Communication Tab of the Control Panel.

Should I be overly worried, the print does not seem to be affected, and I know this is generally a communication error (print via USB). I just started getting this error this week, never seen it at all.

Nothing has changed. Anyone have any input?

Thanks

[TenKOhms]

Which operating system are you running simplify3d on, which baud rate, which printer, which firmware?

[Zekeman]

TenKOhms,

Windows 7 64bit
Baud Rate: 115200
CTC Printer, With Makerware 7.5 FW

[ReneeCelDesigns]

I got the same thing last week. never happened before and courses no problems, has only happened 4 times and seems to have stopped.
I think it my be a minor bug.

Windows 7 64bit
Baud Rate: 115200
FlashForge dual Printer, With Makerware 7.2