Stringing

[john_d12]

Hi
Please could someone help l made a print on my Cr10s I used pla temp 215 and bed temp was set a 70, the print turned out good but I got strings and blobs of filament which weren’t really attached to the print? Please could someone help me.
Thanks

[S3D-Alex]

I would first suggest printing a little cooler as 215 is most likely a little hot for most basic PLA filaments. Can you please post a Factory File so we can look into this a bit more?

[TheBum]

That was my first though as well. PLA typically prints best around 200C, sometimes as far down as 190C.

[dkightley]

Also, have a read of this: You may pick up some useful info.... https://www.simplify3d.com/support/prin ... or-oozing/