i'm running into an issue concerning the first layer. In the image you can see that the layer is not fully complete.
Any help would be appreciate.
Thnaks!
First layer issue
Hello,
i'm running into an issue concerning the first layer. In the image you can see that the layer is not fully complete.
these are my values for the layer configuration: (i have played with first layer values a bit without success)
Any help would be appreciate.
Thnaks!
i'm running into an issue concerning the first layer. In the image you can see that the layer is not fully complete.
these are my values for the layer configuration: (i have played with first layer values a bit without success)
Any help would be appreciate.
Thnaks!
Re: First layer issue
Could you possible post a Factory File so we can offer some assistance? From what you have provided I would immediately recommend a lower first layer height as 120% of .3mm is going to be on the edge of what a .4mm nozzle is capable of. I would also suggest increasing your infill overlap %.
