tThe head brakes several times (like a glitch) in certain places

[poundei]

Hello.
Usually print without brim, only skirt.
And just when printing these two or three rings around the part, the head brakes several times (like a glitch) in certain places, an influx is formed. And when the part is being printed, there is no such thing.
Has anyone watched such a phenomenon? It doesn’t affect print quality, but where does it come from?

[S3D-Alex]

Could you provide a coupe images showing the behavior you are describing? Also a Factory File would be great if you would like advice on specific settings. You can get this by going to File > Save Factory File As...