partial solid infil

[tzutsi]

The ability to specify portions of the object for solid(or increased) infill would be awesome.
Use case: a part that doesn't require 100%, but would benefit from portions to be, like at structural point where surfaces of two parts will be joined, or around bolt holes. If the part is large, printing the entire thing at 100% is a huge wast of time/materials.

[S3D-Jake]

Thanks for your request! I've documented your interest for our developers and will keep an eye out for more interest from other users!

[tonyno]

I like it.

[brearcd1]

That would a useful feature.

[rapapar]

That would a useful feature for me too.