Covid19 stacked face shields

[BlotBot3D]

I created a stack of face shields and want to create a separate profile for each part because I want to control the first layer speed for each part. I did this but the speed does not adjust it runs each first layer at the 60mm/s which is my print speed setting. I just want to adjust the beginning layer not the rest of the layers. Please advise...

[S3D-Alex]

If you are stacking face shields vertically and want the first layer of the each individual shield to be slowed I would recommend using the Variable Settings Wizard. We have a great article that covers this so I included the link below.

https://www.simplify3d.com/support/arti ... f-a-model/

[MthompsonF10]

Good read.