Support or Zortrax M200

[davidbarwin]

Simplify3D has been a tremendous asset to me with my five MakerBot Replicator 2s. I'm looking at replacing the Rep 2s with Zortrax M200s because of my need to move from PLA to ABS (higher temp resistance). I would LOVE to continue to use Simplify3D and I'm hoping I'm not the only one that thinks this. Zortrax looks like a fabulous printer but it needs Simplify3D support. My 2 cents.

[jimc]

i believe the zortrax is completely closed source and doesnt even use gcode of any kind. i doubt any slicer will support the zortrax. if your looking for non warping but also need the temp resistance look into petg filaments. way stronger than abs, no warp like pla and temp resistance the same or only a few deg below abs. this is what colorfabb xt is. there are a few other brands as well. it would be a hell of alot cheaper than buying one or more m200's.