I put on prints that have been printed many times before with no issue;
I also checked bed calibration
Please check these pics; any ideas?
-
Image_Engine
- Posts: 39
- Joined: Mon Nov 06, 2017 6:23 pm
Was working fine...for a long time...now this?
Hi All
I put on prints that have been printed many times before with no issue;
I also checked bed calibration
Please check these pics; any ideas?
I put on prints that have been printed many times before with no issue;
I also checked bed calibration
Please check these pics; any ideas?
Re: Was working fine...for a long time...now this?
It is admittedly a bit difficult to tell what might be happening here. There looks to be under-extrusion? Is this the underside of the part? Could you please post a Factory File where you see this occurring?
