Posts: 2
Joined: Tue Jul 14, 2020 6:31 am

Support & Model NOT aligned (PLA / PVA on Ultimaker S5)

Tue Jul 28, 2020 10:01 pm

Hey there,

I just purchased the license for Simplify 3D - was working with CURA recently - BUT for now I cannot print the model I want to print. Somehow when I slice the model the support structure is not aligned with the model (See attached screenshot.) The settings are the Ultimaker setting with generated support... some advice would be highly appreciated.



Return to “Troubleshooting and Bug Reports”