Delta Bed Leveling Calibration Request

[Jbc]

Please add bed leveling/calibration for delta printers.

[BaudR8]

Please add bed leveling/calibration for delta printers.

I find it (at least on my Orion) easiest to do the following steps on the printer's LCD panel itself:

- Home All Towers
- Incrementally bring Extruder down to bed
- Set New Z-Height
- Home Towers Again
- Run towers.gcode file
- Make Necessary adjustments to end-stop triggers
- Repeat

If your delta has an LCD, no need to level the bed via PC