Hello, Please see the attached screen shots of the slicer software. please note the thin blue line on the right hand side of the model. This is an area that the software did not create support for. I have the support settings at normal and maximun angle at 45 deg, but for some reason the slicer did not create support under this edge… I’m just trying to understand why.
Please advise if possible.
thanks Mark
support issue
Last edited by OKSAILOR on Fri Aug 21, 2020 8:52 am, edited 1 time in total.
Re: support issue
There are no attached screen prints....which make things a little difficult for anyone to help.
What would be useful would be a factory file of what you are wanting to print.. File dropdown===> Save factory file
What would be useful would be a factory file of what you are wanting to print.. File dropdown===> Save factory file
Doug Kightley
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
Re: support issue
Thanks Doug, I though I had those attached. it is a word doc with screen shots from the slicer software.
I can generate a factory file, but thought this might be the first step. and it is telling me that my factory file is too large to load here....
I'm on version 4.0.1 due to printer mfg recommendations. Fusion 3 F410
I can generate a factory file, but thought this might be the first step. and it is telling me that my factory file is too large to load here....
I'm on version 4.0.1 due to printer mfg recommendations. Fusion 3 F410
Re: support issue
You can load your factory file to an external site and link it here. Google drive or Dropbox both offer free file hosting.
"A bird does not sing because it has an answer. It sings because it has a song."
