touchthebitum
Posts: 4
Joined: Sun Jun 14, 2020 2:46 am

unable to switch off retraction

Sun Sep 06, 2020 6:26 am

Hello
I'm struggling against turning off retraction. I checked off all menus but still active.
Any ideas ?

S3D-Alex
Posts: 425
Joined: Thu Aug 30, 2018 1:23 pm

Re: unable to switch off retraction

Tue Sep 08, 2020 11:02 am

In the Extruder tab of the Process settings if you uncheck the box labeled "Retraction" under the Ooze Control section this will ensure no retractions are placed in the gcode.

touchthebitum
Posts: 4
Joined: Sun Jun 14, 2020 2:46 am

Re: unable to switch off retraction

Tue Sep 08, 2020 12:24 pm

already done but it doesn't work ...

S3D-Alex
Posts: 425
Joined: Thu Aug 30, 2018 1:23 pm

Re: unable to switch off retraction

Tue Sep 08, 2020 12:38 pm

Could you please send a gcode file where you are seeing retractions even when the retraction box is unchecked?

touchthebitum
Posts: 4
Joined: Sun Jun 14, 2020 2:46 am

Re: unable to switch off retraction

Tue Sep 08, 2020 12:42 pm

Here it is
Attachments
foot cube no retraction.gcode
(706.52 KiB) Downloaded 21 times

S3D-Alex
Posts: 425
Joined: Thu Aug 30, 2018 1:23 pm

Re: unable to switch off retraction

Tue Sep 08, 2020 1:13 pm

It looks like you have the option labeled "Include M101/M102/M103 commands" enabled. These are older commands that cause primes and retractions so it looks like these are causing retractions to still occur on your printer. Please go to the Gcode tab of the Process Settings and uncheck this box to make sure no retractions occur.

touchthebitum
Posts: 4
Joined: Sun Jun 14, 2020 2:46 am

Re: unable to switch off retraction

Tue Sep 08, 2020 1:20 pm

Ok, I'll try it
Thanks

Return to “Troubleshooting and Bug Reports”