Bugs - GUI and multi-display

[boo]

I'm using Simplify3D on my FlashForge Dreamer quite happily. I have a couple of non-printer-specific bugs to report.

I have the latest version 2.1.2 installed.

1. When zooming in/out on models, the zoom is jerky and goes back/forth repeatedly. I often get 'stuck' when in close and have to struggle to get back to a far view. It's almost as if it's getting stuck and 'bouncing' LOL. Running on a MacBook pro / OSX.

2. When using multiple displays, it becomes impossible to double-click on an object to bring up the model settings window. Double-click simply does not work, on either monitor. If I disconnect the 2nd monitor, then I can double-click.

Overall, very nice piece of software, and I hope that these issues can be resolved quickly

Cheers
A

[jimc]

interesting. i am running on a late 09 27" imac and i dont see this at all. i have dual monitors as well. most 3d software, s3d and cad of anykind will only zoom so far and the closer you get the slower it gets until it almost stops then its a pia to back out. its not jerky though so i dont know if this is what your talking about or not.