Hi,
I am printing a Pumpkin design. My design is printing infill in the middle but the design shows that it should be hollow inside. Does anyone know how to correct this issue?
Thank You
Re: To much infill
ITs almost impossible to give advice based on what information you have provided. It could be one of many different issues!
Please attach a Factory File so we can get an idea of what the issue is.
Factiory file.....with model and profile loaded...File menu ===> Save Factory File.
And you attsch using the strange button below the post window....alongside the word Options
Please attach a Factory File so we can get an idea of what the issue is.
Factiory file.....with model and profile loaded...File menu ===> Save Factory File.
And you attsch using the strange button below the post window....alongside the word Options
Doug Kightley
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
Re: To much infill
Are you sure it's infill & not supports? If it's one piece & not two halves, you will need supports to prevent a hollow sphere from caving in.
Re: To much infill
Silly question, but did you set the infill percentage to 0%?
