Help

[Trickflow]

So I haven't changed any settings and this randomly started. No clue how to fix it im about to wipe everything.

[S3D-Alex]

It looks like you may be printing too far away from the build surface causing these loopy bits instead of a nice flat raft. This may be a settings issue or may be due to an issue with your bed probe. Can you please post a Factory File so we can look into this?

[Trickflow]

Sorry for the late reply, I will post the factory file later today for you. I can't get the hot end to print based on my z offsets it always goes to Z0 instead of Z0 -2.30 offset. But when I send G1 F60 Z0 through my octoprint console it goes where it should.

[Trickflow]

Here is my most recent attempt at printing a bed leveling square.

20x20.factory

(3.76 KiB) Downloaded 246 times

I am going to replace my bltouch just to be sure.