Posts: 1
Joined: Sat Oct 30, 2021 10:16 pm

Automatic Support Generation

When i click the checkmark for generate support and prepare the model to print. the support doesn't support some obvious overhangs for some reason. I wanted to print a character model and it did not even recognize that his hand had no support under it. I have compared it with mesh mixer and it is able to easily recognize that support is needed in that area. Any ideas on how to fix this?
Inkedgenearet support bug_LI.jpg
Posts: 452
Joined: Thu Aug 30, 2018 1:23 pm

Re: Automatic Support Generation

Could you please post a Factory File so we can offer some specific advice for your situation? You can save this by going to File > Save Factory File As...

Return to “Troubleshooting and Bug Reports”