Coordinate Plane Origin Appears to be in a Strange Location

[silverbackprime]

I'm completely willing to believe this is stemming from my lack of understanding of the software, but when I set the position of a model to 0,0,0 s3d shows the model placed out of the build volume past the lower left corner, and underneath the build platform.

I would expect that setting a model's position to 0,0,0 would place it in the most lower left corner of the build volume, directly on top of the build plate. Is that assumption incorrect, or is something off in my settings?

Here's a couple of shots of what I'm seeing:

Model Placed at 0,0,0 in Software (Off of and below build volume)


Model placed in Lower Leftmost Corner (Listed coordinates -5.25, 162.37, 40.78)

Any pointers on what to do would be greatly appreciated...