TallKevin
Posts: 1
Joined: Fri Apr 08, 2022 7:18 pm

Missing Parts Between Model and Print

I am trying to print the attached file and found missing parts/supports when viewing the print and printing.

Unfortunately, the G-Code file is too large to include.
Attachments
Prepare to Print View for COS.jpg
Model View.jpg
S3D-Jake
Posts: 1039
Joined: Wed Jun 20, 2018 12:45 pm

Re: Missing Parts Between Model and Print

1. Make sure your model is manifold and free of self intersecting surfaces. If there are errors, you can typically solve them quickly by importing your model into Microsoft's 3D Builder application and then saving it again.

2. Make sure that if you're attempting to print sections that are thinner than your extrusion width that you have turned on External Single Extrusions in the Thin Wall settings area of the Advanced tab.
"A bird does not sing because it has an answer. It sings because it has a song."

Return to “Troubleshooting and Bug Reports”