Hello everyone, i have been searching all over the support section and cant seem to find an answer to my question. I have read the "poor surface above supports" section and have done everything but nothing seems to be the fix. My main issue is attached in the pictures below. The area above all my supports are stringing too much and within the body it is clear to see each layer individually rather than being one solid part. If you look closely there you can notice that each layer is shown line by line rather than molding as one solid part. The printer is a Builder extreme 2000 with a dual printhead however there is only one extruder being used. I have tried turning the horizontal and vertical separation layers down however the supports end up sticking to the part. I have the print at a 28 degree angle because that allows the print to show all outside layers in the final printing process, I have attached a screenshot to show that the whole part is "blue" which i assumed is what is usually wanted. Here is the following information for the print settings:
-0.8mm nozzle
-PLA filament with1.75mm diameter
- extrusion multiplier: 1.15
- retraction distance: 4.50mm
-extra restart distance: -0.20mm
-coast at end (check) coasting distance: 2.00mm
-top solid layers: 5
-bottom solid layers: 5
-outline/perimeter shells: 5
-infill is on but the parts walls are too small to allow infill unless it is swapped to a 0.4mm nozzle
-horizontal offset from part: 0.7mm
-upper vertical separation layers: 3
-lower vertical separation layers: 5
-default printing speed: 4200 mm/min
-apply bridging settings to perimeters (turned off)