Please add Skirt/Brim setting for internal regions. (See Attached)

[blj1884]

Please add Skirt/Brim setting for internal regions. (See Attached)

[S3D-Jason]

Would a simple checkbox to enable the internal skirt/brim be enough? Or do you think it needs fully independent settings compared to the outer skirt/brim?

[dibor]

Preferably 3 states, internal, external and both.

[gearsawe]

I run into this problem when a part with a large internal opening then place a couple small part inside the opening. Those smaller inside the large opening don't get a brim. this might solve that issue. Have even tried 2 processes and still does not work