ssassen
Posts: 1
Joined: Sat May 27, 2023 9:27 am

Monotonic infill sequence?

The 'monotonic infill sequence' is mentioned as a new feature for 5.1. I'm trying to find this setting but have a hard time locating it? Could anyone perhaps point me in the right direction? Thanks!
S3D-Jason
Posts: 1383
Joined: Sun May 31, 2015 6:01 am

Re: Monotonic infill sequence?

If you type "monotonic" into the search bar in the top right of the process settings window, it will take you to the new settings. It's on the Infill tab. You just enable that checkbox and then the new feature is enabled.
yoda
Posts: 6
Joined: Wed Dec 20, 2023 3:03 am

Re: Monotonic infill sequence?

Hello, in my 5.1.2. version is missing this settings. At tab INFILL is nothink about it ... how can I use it?
S3D-Jason
Posts: 1383
Joined: Sun May 31, 2015 6:01 am

Re: Monotonic infill sequence?

I should be the checkbox at the bottom of the "Solid Layers" section on the Infill tab. It's called "Minimize direction changes (monotonic)"

Return to “General Discussion and Tips”