Would it be possible for someone to write up or even post a video on how to use Simplify3D 2.2's "Bed Leveling Wizard"? I can currently print on the unit with out issues, but I would like to check the level of my Replicator2 print bed using it. Every time I start it, I get this crazy noise that sounds like one of the steppers is being drove into something. I panic and turn off the printer. Cancel doesn't stop it.
BTW nice program. Still getting use to it.
Re: Using the "Bed Leveling Wizard" on MakerBot Replicator 2
I hear the same thing but go through it. It's just the first part for some reason.
