So I did my first print using simplify3D aaand WTH

[Darkly spectre]

M218 T1 X-58.5 Y0
G28 ;Home all axis
T0
G1 Z10 F1000
G1 X200 Y200 F3000
G92 E0
M117 3D yo

Thank you kindly. I really need to learn more about G-Code itself and this whole thing but there is so much information that it is blowing my mind.

a wipe would be handy so that I don't have to sit here with a piece of paper wiping off the oozing filament while it heats

[sully777]

this thing saved me a ton of headaches, had to buy the gauge and magnets but worth every penny. I had though my nozzels where out of level till I used the dial gauge to check them from the base of the printer. But thats a different story, heres the link to thingiverse things http://www.thingiverse.com/search/page: ... +gauge&sa=