first layer width no effect

[jack_n]

Hello,

Changing the first layer width has no effect.

I Tried 100% 125% 150% the part always looks the same on the bottom face.

[jimc]

It definately has an effect. I have tried it as well ad it does work. You should be able to see a difference in you gcode preview. Remember that the actual width is determined by you z height calibration on your machine. The tighter the gap the wider the width.

[jack_n]

Hello,

yes-you are wright.

I did not see this on the part, but in the preview.

Thank you

Joachim