I have problems with the first layer of my prints. I use a raft, but without it's the same. My printer is a MakerBot Replicator 2.
I have set the Global-Z setting to -0.1 mm but that didn't help.
First layer problems
Hello,
I have problems with the first layer of my prints. I use a raft, but without it's the same. My printer is a MakerBot Replicator 2.
I have set the Global-Z setting to -0.1 mm but that didn't help.
Thanks for any help.
I have problems with the first layer of my prints. I use a raft, but without it's the same. My printer is a MakerBot Replicator 2.
I have set the Global-Z setting to -0.1 mm but that didn't help.
Thanks for any help.
Re: First layer problems
V5 has an option for absolute first layer properties which can be really helpful in cases like this. Allows you to precisely control speed, flow rate, etc for the first layer to ensure you have a good finish.
