Rwide
Posts: 2
Joined: Wed Jul 10, 2024 10:57 pm

Feature request: number of perimeters on top/bottom surface

Hi all. I just bought Simplify 3D. I have tested almost every slicer there is out there and after looking through the settings available in S3D I think it looks pretty good. There are many things I like about it. However There is 1 setting that I was dissapointed in not seing. That is number of perimeters in top and bottom surfaces. This makes printed parts look a lot better imo. Maybe I'm wrong but I assume that most users would prefer this over ironing so I was very surprised to see ironing was added before control over perimeters in top/bottom surfaces.
Splitting my models top and bottom surfaces in order to assign an extra procces for this takes forever :(
I hope to se this setting added in the future. It would make me very happy!

Return to “Feature Requests”