tk998
Posts: 2
Joined: Wed Oct 02, 2024 2:37 am

Slicing settings?

Goodmorning all,

Was hoping to get some feedback.

As you can see, the inner perimeter of this object wont slice correctly (it should not have these gaps in between the 3 holes).
I had my settings all setup but due to my computer crashing i'll have to fine tune settings again.

I think i'm missing something because before my computer crashed, slicing this was not a problem at all.
Any tips are welcome?
Attachments
slice.pdf
(389.98 KiB) Downloaded 711 times
tk998
Posts: 2
Joined: Wed Oct 02, 2024 2:37 am

Re: Slicing settings?

also, find attached my current printer profile/settings for the cubicon single plus.
Attachments
setting cubico nsingle plus.factory
settings for cubicon single plus
(5.48 KiB) Downloaded 831 times
S3D-Taylor
Posts: 55
Joined: Tue Jun 20, 2023 10:55 am

Re: Slicing settings?

Looks like this is due to the thin cavity walls. This article should help: https://www.simplify3d.com/resources/ar ... -features/. Reducing your Extrusion Width manually to 0.4 should help as well.

Return to “Troubleshooting and Bug Reports”