Bridging gcode generation seems to have a global positioning dependence
Depending on the position of the model bridging can be either close or "far" away from the perimeter, I feel like this is going to cause inconsistencies when printing multiple of the same model. I have attached 2 pictures where bridging parameters were not changed, only the position of the model was changed. Also love the feature "bridging infill extra expansion", works great as it allows the acceleration to occur before the nozzle is over the air gap.
(Also sorry for spamming the forum today, I am a pretty heavy user and have been stuck on 4.0.1 due to the better rafts on that version and finally bit the bullet and spent the last few days writing a python script to change the rafts in 5.1.2 to be better so I can also have access to the new 5.1.2 features, and have noticed a few things)
(Also sorry for spamming the forum today, I am a pretty heavy user and have been stuck on 4.0.1 due to the better rafts on that version and finally bit the bullet and spent the last few days writing a python script to change the rafts in 5.1.2 to be better so I can also have access to the new 5.1.2 features, and have noticed a few things)
