Variable Settings - Not along Z

[Monty3DP]

Hello folks,

Straight to the point... I'm printing a fairly large model that has screw towers. I want to print the model at 5% infill but this leaves the skinny screw towers with no infill and therefore, very week.

How can i maintain the 5% for the whole model but have say 50% for the screw towers

Cheers

[S3D-Taylor]

Reducing the Solid Infill Threshold Area should help. It will convert the screw towers, if they have area smaller than this value, into using solid infill for strengthening.

[Monty3DP]

Thanks a lot! This worked a treat