dsegel wrote:I see that occasionally as well. Usually I get around it by moving the support or changing the size of the support. It's definitely a bug.
How do you change the size of the support? Also: can you help me with the following issues?
I need help setting the following support parameters:
1) Support pillar extrusion width. (This may be an option I don't recognize)
2) Density of support pillars. (I suspect this has to do with "Support Pillar Resolution", which has a tool tip of "Determines the resolution used for support material calculation") BTW: What is "Support Pillar Resolution?" Is it pillar density ... the number of pillars/square mm? And, what is a pillar?
3) "Support infill percentage" Purportedly adjusts the spacing between support material webbing. How does "support material webbing" differ from "support pillar"?
It's probably more direct for me to ask the following:
A) Support Pillar Resolution: How does the printed support for a high setting compare with that of a low setting?
B) Support infill Percentage :
How does the printed support for a high setting compare with that of a low setting?
C) What is value of "Dense Support Layer"?
I welcome any advice on the application of these settings.
Make Better Things.
Make Things Better.