-
ACertainReality
- Posts: 2
- Joined: Wed Apr 30, 2025 2:41 am
Top geometry cutting into bottom layer
I want to print a single layer thin sheet with some geometry on top, But instead of it printing a continuous initial layer it cuts it where the geometry lays on top, Any help would be appreciated.
- Attachments
-
-
S3D-Taylor
- Posts: 101
- Joined: Tue Jun 20, 2023 10:55 am
Re: Top geometry cutting into bottom layer
Increasing the value of Top Layer Extra Expansion should solve this. The post here explains a bit further: viewtopic.php?p=74471#p74471
-
ACertainReality
- Posts: 2
- Joined: Wed Apr 30, 2025 2:41 am
Re: Top geometry cutting into bottom layer
Nice this helpedS3D-Taylor wrote: ↑Wed Apr 30, 2025 10:30 am Increasing the value of Top Layer Extra Expansion should solve this. The post here explains a bit further: viewtopic.php?p=74471#p74471
