Not a big problem though.
-
dreyfusduke
- Posts: 14
- Joined: Tue Sep 09, 2014 4:40 pm
Rostock Max V2 won't start print
Rostock max won't start print from USB. Everything else seems to work perfectly with the jog controls. Start from USB just sends the extruder head down to start position and it sits there. I can save to SD card and print from there just fine though. Getting some beautiful prints I might add with just a few changes to settings.
Not a big problem though.
Not a big problem though.
Re: Rostock Max V2 won't start print
can you send a screenshot of the communication tab (machine control panel) of what is being transmissted before, during, and after the pausing?
-
dreyfusduke
- Posts: 14
- Joined: Tue Sep 09, 2014 4:40 pm
-
dreyfusduke
- Posts: 14
- Joined: Tue Sep 09, 2014 4:40 pm
Re: Rostock Max V2 won't start print
I have never tried to print from USB with S3D, just use the SD card and not worry about other problems that creep up from printing via usb.
-
dreyfusduke
- Posts: 14
- Joined: Tue Sep 09, 2014 4:40 pm
Re: Rostock Max V2 won't start print
That has what I have been doing. No big issues using that route so far. Been working great so far. Only issues I have had have been traced back to a faulty STL file that just needed repaired.
