ok so I cant figure it out? I've tried turning up the infill width (up to 175%and everywhere in between) and that would look pretty good but after printing about 5-10 layers it would stop extruding so I have tried turning up the temp and now im back to broken infill patterns again....I have been battling with this for about 3-4 hours now and haven't been able to fix what I thought would have been pretty easy to fix.
the only place there is infill left is where the patterns cross just leaving pillars.
any suggestions? I have read a bunch of other threads on here about this but nothing seems to be helping?
can I turn down the infill travel speed?
Thanks