Post Reply
Rhelsing
Posts: 1
Joined: Sun Feb 22, 2015 9:43 am

Wifi

The Flashforge Dreamer allows print by wifi, which was the only nice thing about whatever software was their default. Any chance of a future upgrade allowing that?
User avatar
DarthRevan
Posts: 480
Joined: Wed Feb 18, 2015 8:29 am

Re: Wifi

Wifi compatibility would be nice. However I ALWAYS watch my first few layers get printed, so I may as well bring my SD card over t the party anyways. :D
SockMonkey
Posts: 22
Joined: Thu Feb 26, 2015 7:22 pm

Re: Wifi

DarthRevan wrote:Wifi compatibility would be nice. However I ALWAYS watch my first few layers get printed, so I may as well bring my SD card over t the party anyways. :D
Very valid point, I agree!
Post Reply

Return to “General Discussion and Tips”