S3D Successful Prints

[JoeJ]

Wow! These are some great prints! I love the glow in the dark skull

[somepunk22]

Finally I thought I would put my new ToyBuilderLabs Glow-In-the-Dark PLA to test! You really start crossing your fingers towards the end of a 32 hour print, especially when the filament is $50 a roll!

I had previously printed a small version but it has been confiscated by my 18 month old daughter!
http://www.thingiverse.com/make:66936

I knew this was going to be a lengthy print so a couple hours in I decided to setup a time lapse video of the whole thing. I'm glad it all worked out, now I can share the fun with you guys. Watch for a cameo at around 25 seconds.

Video https://www.youtube.com/watch?v=d7sHiVf ... e=youtu.be

I didn't have time to remove it from the plate this morning but I will do that this evening and probably make a video so people who haven't worked with Simplify3D can see how nice the supports can be removed from the part. I'll also put it on Thingiverse with a Glowing shot!

Great looking print. Can you share your printer mods? I have the same, but mine needs some upgrades. Thanks.