Re: Your firmware does not support real-time speed changes.
Posted: Wed Aug 08, 2018 11:43 am
I don't think it's a S3D problem but a limitation in the FFCP/firmware (again I'm passing on what I was told, hoping to be proven wrong).
I still have version 3.1.1 on my Mac and it's never been able to adjust speed or extrusion multiplier from the S3D machine control panel.rich17950 wrote: ↑Mon Aug 06, 2018 9:23 am Yes I am using the jog control dashboard while connected and printing via USB not from mem card., I had always been able to do it with ver. 3 and my old machine. Also this machine has the latest Sailfish firmware 7.8 from factory.
Adjusting on the fly was a nice feature that allowed me to fine tune while printing.
Thanks Rich