Page 2 of 2
Re: Skirt won't print if global z offset is negative and larger than layer height
Posted: Thu Sep 19, 2019 5:14 pm
by grue19
hey so i recently i ran into the ability to print 2 layers of a brim/skirt (and presumably as many as i want). so if you set your brim layers to 2 or 3 does it print even with the negative z offset?
Re: Skirt won't print if global z offset is negative and larger than layer height
Posted: Thu Sep 19, 2019 9:38 pm
by paynterf
Don't know, but the next time I print on my dual-extruder PowerSpec I'll check and let you know
Frank
Re: Skirt won't print if global z offset is negative and larger than layer height
Posted: Fri Sep 20, 2019 9:23 am
by S3D-Alex
Paynterf could you please post a Factory File where you see the skirt not being printed? I was not able to replicate this here.