Page 2 of 2
Re: Brim acting weird
Posted: Mon Mar 23, 2015 8:27 pm
by KC_703
Is it the same spot on the bed? Maybe a good cleaning will help.
If not, seems as though it may be a cold spot on the bed... IR thermometer could help diagnose.
Re: Brim acting weird
Posted: Tue Mar 24, 2015 9:46 am
by dexter.day
We are actually seeing this issue across the bed in different areas anytime we use a brim--and only on the brim, not on the bottom layer of the actual part. We clean the bed every few parts.
Re: Brim acting weird
Posted: Tue Mar 24, 2015 8:35 pm
by KC_703
Hmm... interesting. I've experienced this on a bed that was too cold or still heating up. Obvious fix there was to with for proper pre-heat.
The other thought could be to increase the first layer height and width for better adhesion... Though if its not affecting the first layer of the print, I wouldn't worry too much.
Re: Brim acting weird
Posted: Tue Mar 24, 2015 8:36 pm
by KC_703
Hmm... interesting. I've experienced this on a bed that was too cold or still heating up. Obvious fix there was to with for proper pre-heat.
The other thought could be to increase the first layer height and width for better adhesion... Though if its not affecting the first layer of the print, I wouldn't worry too much.