Page 2 of 2
Re: Reload Stl-file from disk
Posted: Wed Nov 29, 2017 4:13 pm
by Chappo
+1
Re: Reload Stl-file from disk
Posted: Thu Nov 30, 2017 6:36 pm
by benstuyts
+1
Slic3r has this and I find it a real timesaver.
Re: Reload Stl-file from disk
Posted: Sun Dec 03, 2017 3:48 pm
by LayerFace
+1. I was a bit shocked to find that a piece of $150 software doesn't already have this. Bit embarrassing. People have been asking for this since 2014. Can't we get this done sharpish? Iterating on model design is a pain without this.
LF
Re: Reload Stl-file from disk
Posted: Thu Dec 07, 2017 7:38 pm
by hoangnam
Not sure if this company listening to our voices or not but this feature is a must have as a usability need. The request for this was from 2015 for godsake and no one from this company have responded to this post. I'm so regretting paying 150 for this software company for such a lousy support.
+1
Re: Reload Stl-file from disk
Posted: Fri Dec 08, 2017 6:45 pm
by railgunner
+1
Re: Reload Stl-file from disk
Posted: Thu Jan 04, 2018 4:46 am
by vindolin
+1
Re: Reload Stl-file from disk
Posted: Thu Jan 11, 2018 1:40 pm
by gotswrv
+1
Re: Reload Stl-file from disk
Posted: Sun Jan 14, 2018 5:36 pm
by davidhbrown
+1
Not being able to do this sabotages much of the value of being able to specify different processes per model. Such a pain to have to delete/reload/re-orient, re-position, re-select objects for all the processes...
Re: Reload Stl-file from disk
Posted: Sat May 02, 2020 7:47 pm
by benraay
+1
Re: Reload Stl-file from disk
Posted: Wed May 13, 2020 11:47 pm
by rob49152
+1
This would be incredibly handy after manually placing supports and discovering you need to change something on the model.