Simplify3D User Forum

Posted: **Wed Nov 11, 2015 5:24 pm**

Here are my examples. It strongly suggests something in the layer heights is unhappy.

Using S3D 3.2 on a printer-dedicated 5ish year old Mac Mini using OS 10.6.8. No other software installed except stock Apple software, S3D, and Google Drive. Never had a problem with this until version 3.

: .2500 layer height; bridge.jpg (32.57 KiB) Viewed 2417 times

: .2000 layer height is the only change I made; good.jpg (32.39 KiB) Viewed 2417 times

Posted: **Wed Nov 11, 2015 5:27 pm**

This one is .2000 height rotated. I did not include a 2nd "fixed" pic, but when I switch the rotated model to .2500 layer height the bridge disappears.

Posted: **Wed Nov 11, 2015 8:00 pm**

Pictures only are not enough for issue investigation. Please post the factory files for these two parts. Then if S3D support need any evidence, they can use the data...

Simplify3D User Forum

Printing bridge over the hole

Re: Printing bridge over the hole

Re: Printing bridge over the hole

Re: Printing bridge over the hole