[ADDED] Select where layer outlines begin.

[vOidward]

Hope I'm not overstepping with what I've been told.
I asked support for an ETA on this feature (very important for me) and was told it's already completed and will be included in the next update.

"The developers said you will actually be able to choose the location where all start points are aligned to. So, for example, if you printed 3 different models at once, each one could have a different location where the start point seam would be aligned to."

Now if only we knew when the next update will drop...

[3Drasle]

Hope I'm not overstepping with what I've been told.
I asked support for an ETA on this feature (very important for me) and was told it's already completed and will be included in the next update.

"The developers said you will actually be able to choose the location where all start points are aligned to. So, for example, if you printed 3 different models at once, each one could have a different location where the start point seam would be aligned to."

Now if only we knew when the next update will drop...

That is great news.
Thank you for sharing, can't wait for testing this feature!

/Michael

[marcnicol]

Thanks so much for sharing. The only problem is now I'm desperate for the update.

Anyone know when the next release will be?

[S3D-Jason]

This feature was added in version 2.1